Table of Contents
Advertisement
Visual Inspection for External Damage
Safety and Function Tests
Detaching Protective Panels
Detaching Insulation Blanket
E 2008 Nordson Corporation
WARNING: When damaged parts pose a risk to the operational safety of
the melter and/or safety of personnel, switch off the melter and have the
damaged parts replaced by qualified personnel. Use only original Nordson
spare parts.
During power up of the melter, the lights in the light tower are all switched
on briefly as a test. The operator should check whether all lights function
properly. Replace defective lamps.
Open the protective panels with a 4 mm Allan key.
Fig. 5-1
1. Release Velcro and clamps.
2. Take insulation blanket out of hooks.
1
1
Fig. 5-2
VBN w/o Control System
Maintenance
On the inside
2
2
P/N 7146386A
5-5
Advertisement
Table of Contents
Troubleshooting
