Ricoh D3D9 Field Service Manual page 79

0- Not used
2
3 Printing dedicated TX
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
4- Not used
7
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function
0 Addition of image data from
confidential transmissions on the
transmission result report
0: Disabled 1: Enabled
1 Print timing of communication reports
on the Journal when no image data was
exchanged.
0: After DCS/NSS communication
(default),
1: After polling
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the error
report
0: No 1: Yes
4 Not used
5 Power failure report
0: Disabled
1: Enabled (default)
Do not change these settings.
1: Each Quick/Speed dial number on the list is printed with the
dedicated TX parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated TX
parameters; 34 bytes of data are printed (the other 24 bytes have no use
for service technicians).
Do not change these settings.
Comments
If this feature is enabled, the top half of the first page of
confidential messages will be printed on transmission result
reports.
0: The Journal is printed only when image data is sent.
1: The Journal is printed when any data is sent.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which occurs rarely.
Do not change this setting.
1: A power failure report will be automatically printed after the
power is turned ON if a fax message disappeared from the
memory when the power was turned off last.
NOTE: If "0" is selected, no reports are printed and no one
4.Service Tables
75