Ricoh D3D9 Field Service Manual page 126

4.Service Tables
No. Function
0 Network I/F setting for SIP
connection
0: IPv4
1: IPv6.
1 Network I/F setting for Fax
communication
0: Same setting as SIP server
connection
1: Automatic setting
2 Record-route setting
0: Disable
1: Enable
3-4 re-INVITE transmission delay
timer setting
Bit 4 Bit 3
0 0
0 1
1 0
1 1
5 SIP-IPFAX: Adding vender
information selection
0: Declare
T38VendorInfo=RICOH
1: Not declare
T38VendorInfo=RICOH
6-7 Not used.
IP Fax Switch 0A - Not used (do not change the settings)
IP Fax Switch 0B - Not used (do not change the settings)
IP Fax Switch 0C - Not used (do not change the settings)
IP Fax Switch 0D - Not used (do not change the settings)
IP Fax Switch 0E (SP No. 1-111-013)
No. Function
0-1 SIP: IP-FAX port mode
(UDP)
00: 3 port mode
122
Comments
Selects the connection type (IPV4 or IPV6) to connect to the SIP
server.
0: The I/F setting for fax communication follows the setting for SIP
server connection.
1: The negotiation between the SIP server and the device decides
whether IPv4 or IPv6 is used for the I/F setting for fax
communication.
0: Disables the record-route function of the SIP server.
1: Enables the record-route function of the SIP server.
This changes the interval for transmit re-INVITE after receiving
the ACK message transmitted by T.38 device.
No delay
1 sec
2 sec
3 sec
0: Use this setting normally.
1: This setting is used only when a customer wants to connect the
machine with SIP server + VOIP-GW provided by AVAYA Inc.
Do not change these settings.
Comments
Switch the port mode for IP-FAX (T38 transport: UDP) at SIP call
control.