Ricoh D3D9 Field Service Manual page 83

No Function
0 Not used
1 Going into the Energy Saver mode
automatically
0: Enabled
1: Disabled
2- Not used
3
4- Interval for preventing the machine
5 from entering Energy Saver mode if
there is a pending transmission file.
Bit 5 Bit 4
0 0
0 1
1 0
1 1
6- Not used
7
System Switch 16 (SP No. 1-101-023)
No Function
0 Parallel Broadcasting
0: Disabled
1: Enabled
1 Priority setting for the
G3 line.
0: PSTN-1 > PSTN-2
or 3
1: PSTN-2 or 3 >
PSTN-1
2- Not used
7
System Switch 17 - Not used (do not change these settings)
System Switch 18 - Not used (do not change these settings)
Comments
Do not change the settings.
1: The machine will restart from the Energy Saver mode
quickly, because the +5V power supply is active even in the
Energy Saver mode. The LED of the operation switch is
flashing instead of entering Energy Saver mode.
Use this setting if an external telephone has to be used when
the machine is in the Energy Saver mode.
Do not change these settings.
If there is a file waiting for transmission, the machine does not
go to Energy Saver mode during the selected period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver mode.
Setting
1 min
30 min
1 hour
24 hours
Do not change
Comments
1: The machine sends messages simultaneously using all available ports during
broadcasting.
NOTE: If a customer wants to keep a line available for fax reception or other
reasons, select "0" (Disable).
This function allows the user to select the default G3 line type. The optional
SG3 units are required to use the PSTN-2 or 3 setting.
Do not change these settings.
4.Service Tables
79