Ricoh D3D9 Field Service Manual page 100

4.Service Tables
1 Acceptable total error line ratio
0: 5% 1: 10%
2 Treatment of pages received with
errors during G3 reception
0: Deleted from memory without
printing
1: Printed
3 Hang-up decision when a negative
code (RTN or PIN) is received
during G3 immediate transmission
0: No hang-up, 1: Hang-up
4- Not used
7
Communication Switch 03 (SP No. 1-104-004)
No Function
0- Maximum number of page retransmissions in a G3 memory
7 transmission
Communication Switch 04 (SP No. 1-104-005)
No Function
0 Remote mode switch
(TEL mode)
0: Disable
1: Enable (Active)
1 Remote mode switch
(FAX mode)
0: Disable
1: Enable (Active)
2 Remote mode switch
(AUTO mode)
0: Disable
1: Enable (Active)
96
300 dpi
400 dpi
If the error line ratio for a page exceeds the acceptable ratio, RTN
will be sent to the other end.
0: Pages received with errors are not printed.
0: The next page will be sent even if RTN or PIN is received.
1: The machine will send DCN and hang up if it receives RTN or
PIN.
This bit is ignored for memory transmissions or if ECM is being
used.
Do not change these settings.
Comments
Set this bit to ON when you wish to switch TEL mode to FAX mode
remotely.
Set this bit to ON when you wish to turn on the remote mode switch after
automatic reception with FAX mode.
Set this bit to ON when you wish to turn on the remote mode switch after
automatic reception with AUTO mode.
18(L) 36(H)
24(L) 48(H)
Comments
00 - FF (Hex) times.
This setting is not used if ECM is
switched on.
Default setting - 03(H)