Ricoh D3D9 Field Service Manual page 44

3.Troubleshooting
Code
0-06 The other terminal did not reply to DCS
0-07 No post-message response from the
other party after a page was sent
0-08 The other party sent RTN or PIN after
receiving a page, because there were too
many errors
0-14 Non-standard post message response
code received
0-15 The other terminal is not capable of
40
Meaning Suggested Cause/Action
•
Check the connection.
•
Try adjusting the TX level and/or cable equalizer
settings.
•
Replace the FCU.
•
The other party may be defective or incompatible; try
sending to another machine.
•
Check for line problems.
Reference:
See error code 0-04.
•
Check the connection.
•
Replace the FCU.
•
The other party is out of paper or has a paper jam.
•
The other party may have disconnected the call.
•
Check for a bad line.
•
The other machine may be defective. Try sending to
another machine.
•
Check the connection.
•
Replace the FCU.
•
The other party may have a paper jam, or run out of
paper or memory space.
•
Try adjusting the TX level and/or cable equalizer
settings.
•
The other party may have a defective modem/FCU; try
sending to another machine.
•
Check for line problems and noise.
Reference:
•
TX level: NCU Parameter 01 (PSTN)
•
Cable equalizer: G3 Switch 07 (PSTN)
•
Dedicated TX parameters in Service Program Mode
•
Incompatible or defective remote terminal; try sending
to another machine.
•
Noisy line; resend.
•
Try adjusting the TX level and/or cable equalizer
settings.
•
Replace the FCU.
Reference:
See error code 0-08.
The other party is unable to accepting the following