Ricoh D3D9 Field Service Manual page 14

1.Installation
11. Connect the two modular harnesses [A] (LINE1: 3 pin) and [B] (TEL: 2 pin) to the FCU.
12. Reinstall the controller box cover and the rear middle cover.
13. Connect the telephone cord to the "LINE 1" jack.
14. Attach the serial number decal under the machine serial number decal on the rear cover of the machine.
15. Attach the FCC decal on the rear cover of the machine (NA only).
16. Keep the EMC address decal at the customer site (EU only).
17. Insert the power plug into the outlet. Turn ON the main power of the machine.
•
Make sure that the outlet is grounded.
•
"SRAM formatted" is displayed on the operation panel after the main power is turned ON. Turn the
main power OFF and then ON again for normal use.
Adding Fax Application Icons to the Home Screen
The fax application icon is normally added automatically. However, if it is missing from the Home screen, add it
as follows:
1.
Press the [Application List] key [A].
10