Ricoh D3D9 Field Service Manual page 141

1 0 1
1 1 0
1 1 0
1 1 1
1 1 1
Other settings: Not used
4- Not used
7
Switch 03
No FUNCTION
0- Inch-mm conversion
1 before TX
Bit 1: 0, Bit 0: 0
= Inch-mm conversion
available
Bit 1: 0, Bit 0: 1 = Inch
only
Bit 1: 1, Bit 0: 0 = Not
used
Bit 1: 1, Bit 0: 1 =
Disabled
2- DIS/NSF detection
3 method
Bit 3: 0, Bit 2: 0
= First DIS or NSF
Bit 3: 0, Bit 2: 1
= Second DIS or NSF
Bit 3: 1, Bit 2: 0 = Not
used
Bit 3: 1, Bit 2: 1 =
Disabled
4 V.8 protocol
0: Off
1: Disabled
5 Compression modes
available in transmit
1 26400
0 28800
1 31200
0 33600
1 Disabled
Do not change the settings.
COMMENTS
If "inch only" is selected on the machine uses inch-based resolutions for
scanning, the printed copy may be slightly distorted at the other end if that
machine uses mm-based resolutions.
If the setting is "Inch-mm conversion available ", Inch-mm conversion become
effective to the special senders.
If the setting is "Disabled", the bit switch setting is used.
(0, 1): Use this setting if echoes on the line are interfering with the set-up
protocol at the start of transmission. The machine will then wait for the second
DIS or NSF before sending DCS or NSS.
If the setting is "Disabled", the bit switch setting is used.
If transmissions to a specific destination always end at a lower modem rate
(14,400 bps or lower), disable V.8 protocol so as not to use V.34 protocol.
0: V.34 communication will not be possible.
If the setting is "Disabled", the bit switch setting is used.
This bit determines the capabilities that are informed to the other terminal
during transmission.
4.Service Tables
137