Finding Feature Information - Cisco Catalyst 3650 Configuration Manual

IP Multicast Optimization: PIM Dense Mode State
Refresh
•
•
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisite for PIM Dense Mode State Refresh
• You must have PIM dense mode enabled on an interface before configuring the PIM Dense Mode State
OL-29890-01
Finding Feature Information, page 341
Prerequisite for PIM Dense Mode State Refresh, page 341
Restrictions on PIM Dense Mode State Refresh, page 342
Information About PIM Dense Mode State Refresh, page 342
How to Configure PIM Dense Mode State Refresh, page 343
Configuration Examples for PIM Dense Mode State Refresh, page 345
Additional References, page 345
Feature History and Information for PIM Dense Mode State Refresh, page 347
Refresh feature.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
17
C H A P T E R
341