Configuring Ra Guard (Cli) - Cisco Catalyst 3650 Configuration Manual

Configuring RA Guard (CLI)

Command or Action
Step 3
ipv6 mld snooping vlan vlan-id mrouter interface
Port-channel port-channel-interface-number
Example:
Device(config)# ipv6 mld snooping vlan 2 mrouter
interface Port-channel 22
Configuring RA Guard (CLI)
SUMMARY STEPS
1. enable
2. configure terminal
3. ipv6 nd raguard policy policy-name
4. trusted-port
5. device-role {host | monitor | router | switch}
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ipv6 nd raguard policy policy-name
Example:
Device(config)# ipv6 nd raguard policy
myraguardpolicy
Step 4
trusted-port
Example:
Device(config-nd-raguard)# trusted-port
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
222
Configuring Wireless Multicast
Purpose
Configures a Layer 2 port as a Multicast router port.
The VLAN is the client VLAN.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global command mode.
Configures a policy for RA Guard.
Sets up a trusted port.
OL-29890-01