Connecting The Console Port Of The Device; Logging On To The Web Gui; Enabling Web And Secure Web Modes - Cisco Catalyst 3650 Configuration Manual

Ip multicast routing
Hide thumbs Also See for Catalyst 3650:
Table of Contents

Advertisement

Using the Web Graphical User Interface

Connecting the Console Port of the Device

Before You Begin
Before you can configure the device for basic operations, you need to connect it to a PC that uses a VT-100
terminal emulation program (such as HyperTerminal, ProComm, Minicom, or Tip).
Step 1
Connect one end of a null-modem serial cable to the device's RJ-45 console port and the other end to your PC's serial
port.
Step 2
Plug the AC power cord into the device and a grounded 100 to 240 VAC, 50/60-Hz electrical outlet. Turn on the power
supply. The bootup script displays operating system software initialization (code download and power-on self-test
verification) and basic configuration. If the device passes the power-on self-test, the bootup script runs the configuration
wizard, which prompts you for basic configuration input.
Step 3
Enter yes. Proceed with basic initial setup configuration parameters in the CLI setup wizard. Specify the IP address for
the service port which is the gigabitethernet 0/0 interface.
After entering the configuration parameters in the configuration wizard, you can access the Web GUI. Now, the device
is configured with the IP address for service port.

Logging On to the Web GUI

Enter the device IP address in your browser's address bar. For a secure connection, enter https://ip-address. For a less
secure connection, enter http://ip-address.

Enabling Web and Secure Web Modes

Step 1
Choose Configuration > Switch > Management > Protocol Management > HTTP-HTTPS.
The HTTP-HTTPS Configuration page appears.
Step 2
To enable web mode, which allows users to access the device GUI using "http://ip-address," choose Enabled from the
HTTP Access drop-down list. Otherwise, choose Disabled. Web mode (HTTP) is not a secure connection.
OL-29890-01
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)

Connecting the Console Port of the Device

15

Advertisement

Table of Contents
loading

Table of Contents