Enabling Snmp Monitoring Of Msdp - Cisco Catalyst 3650 Configuration Manual

Configuring MSDP
Command or Action
Step 2
clear ip msdp peer [peer-address | peer-name]
Example:
clear ip msdp peer
Device#
Step 3 clear ip msdp statistics [peer-address |
peer-name]
Example:
Device# clear ip msdp statistics
Step 4 clear ip msdp sa-cache [group-address]
Example:
Device# clear ip msdp sa-cache

Enabling SNMP Monitoring of MSDP

Perform this optional task to enable Simple Network Management Protocol (SNMP) monitoring of MSDP.
Before You Begin
• SNMP and MSDP is configured on your devices.
• In each PIM-SM domain there should be a device that is configured as the MSDP speaker. This device
• All MSDP-MIB objects are implemented as read-only.
Note
• The Requests table is not supported in Cisco's implementation of the MSDP MIB.
• The msdpEstablished notification is not supported in Cisco's implementation of the MSDP MIB.
OL-29890-01
must have SNMP and the MSDP MIB enabled.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Purpose
Clears the TCP connection to the specified MSDP peer and resets
all MSDP message counters.
Clears the statistics counters for the specified MSDP peer and resets
all MSDP message counters.
Clears SA cache entries.
• If the clear ip msdp sa-cache is specified with the optional
group-address argument or source-addressargument, all SA
cache entries are cleared.
• Use the optional group-address argument to clear all SA cache
entries associated with a specific group.
Enabling SNMP Monitoring of MSDP
207