Displaying Igmp Snooping Information - Cisco Catalyst 3650 Configuration Manual

Configuring IGMP
Command
show ip igmp static-group {class-map [
interface [ type ] ]
show ip igmp vrf

Displaying IGMP Snooping Information

You can display IGMP snooping information for dynamically learned and statically configured router ports
and VLAN interfaces. You can also display MAC address multicast entries for a VLAN configured for IGMP
snooping.
Table 11: Commands for Displaying IGMP Snooping Information
Command
show ip igmp snooping detail
show ip igmp snooping groups [ count |
[vlan vlan-id [A.B.C.D | count ] ]
show ip igmp snooping igmpv2-tracking
show ip igmp snooping mrouter [vlan
vlan-id]
OL-29890-01
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Displaying IGMP Snooping Information
Purpose
Displays static group information.
Displays the selected VPN routing/forwarding instance by
name.
Purpose
Displays the operational state information.
Displays multicast table information for the device or about
a specific parameter:
• count—Displays the total number of groups.
• vlan—Displays group information by VLAN ID.
Displays the IGMP snooping tracking.
This command displays group and IP address
Note
entries only for wireless multicast IGMP joins and
not for wired IGMP joins. Wireless IP multicast
must be enabled for this command to display.
Displays information on dynamically learned and manually
configured multicast router interfaces.
Note When you enable IGMP snooping, the device
automatically learns the interface to which a
multicast router is connected. These are
dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a
single VLAN.
79