Changing The Igmp Query Timeout For Igmpv2 (Cli) - Cisco Catalyst 3650 Configuration Manual

Changing the IGMP Query Timeout for IGMPv2 (CLI)

Command or Action
Step 6
show ip igmp interface [interface-id]
Example:
Device# show ip igmp interface
Step 7 copy running-config startup-config
Example:
Device# copy running-config
startup-config
Changing the IGMP Query Timeout for IGMPv2 (CLI)
If you are using IGMPv2, you can specify the period of time before the device takes over as the querier for
the interface. By default, the device waits twice the query interval period controlled by the ip igmp
query-interval interface configuration command. After that time, if the device has received no queries, it
becomes the querier.
This procedure is optional.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ip igmp querier-timeout seconds
5. end
6. show ip igmp interface [interface-id]
7. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
40
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Configuring IGMP
OL-29890-01