Monitoring Pim - Cisco Catalyst 3650 Configuration Manual

Configuring PIM
Command or Action
Step 6
show ip igmp interface [interface-id]
Example:
Device# show ip igmp interface
Step 7 copy running-config startup-config
Example:
Device# copy running-config
startup-config

Monitoring PIM

Use the privileged EXEC commands in the following table to monitor your PIM configurations.
Table 15: PIM Monitoring Commands
Command
show ip pim all-vrfs tunnel [tunnel tunnel_number
| verbose]
show ip pim autorp
show ip pim boundary
show ip pim interface
show ip pim neighbor
show ip pim tunnel [tunnel | verbose]
show ip pim vrf { word { all-vrfs | autorp |
boundary | bsr-router | interface | mdt | neighbor
| rp | rp-hash | tunnel } }
OL-29890-01
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Purpose
Displays all VRFs.
Displays global auto-RP information.
Displays information about mroutes filtered by
administratively scoped IPv4 multicast boundaries
configured on an interface.
Displays information about interfaces configured for
Protocol Independent Multicast (PIM).
Displays the PIM neighbor information.
Displays information about Protocol Independent
Multicast (PIM) tunnel interfaces
Displays the VPN routing/forwarding instance.

Monitoring PIM

155