Configuring Per Interface Igmp State Limiters - Cisco Catalyst 3650 Configuration Manual

Configuring IGMP State Limiters
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
ip igmp limit number
Example:
Device(config)# ip igmp limit 150
Step 4 end
Example:
Device(config-if)# end
Step 5
show ip igmp groups
Example:
Device# show ip igmp groups
Related Topics
IGMP State Limit, on page 350
Configuring IGMP State Limiters Example, on page 354

Configuring Per Interface IGMP State Limiters

Perform this optional task to configure a per interface IGMP state limiter.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
352
IP Multicast Optimization: IGMP State Limit
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures a global limit on the number of mroute states resulting
from IGMP membership reports (IGMP joins).
Ends the current configuration session and returns to privileged
EXEC mode.
(Optional) Displays the multicast groups with receivers that are
directly connected to the device and that were learned through
IGMP.
OL-29890-01