Table of Contents
Advertisement
8.13.6
RS485 number of stop bits
This parameter defines the number of stop bits for the RS485 interface.
Value
0 (default)
1
8.13.7
RS485 Modbus address
This parameter defines the Modbus address (1 to 255) for communication via the RS485
interface with the Modbus protocol.
8.13.8
Decimal place for Siebert indicator
A fixed decimal place must be specified if a Siebert indicator is used. The following values
are permitted: 0 ... 4
8.14
DR 14 Selection process value 1, 2
The weighing module can communicate with an S7-1200 CPU in two ways: Via the I/O only
or by reading/writing complete data records. The I/O is faster in this case and exhibits a
higher performance because the data is made available to the S7-1200 or SIWAREX
automatically in each PLC cycle. Using two user-definable channels in the S7-I/O (process
value 1 and process value 2), the user can decide which scale values (see table) are to be
made available cyclically to the PLC in these two parameters.
Table 8- 13
Process value
No value selected
Gross weight
Gross/net weight (default)
Tare weight
Gross process weight
Gross/net process weight
Tare process weight
Net weight x10
Status of analog output, digital out-
puts and inputs (see table)
NAWI Status bits (default)
Refresh counter
SIWAREX WP251
Manual, 12/2015, A5E37203357A
Stop bits
1
2
Selection table for process value 1,2
8.14 DR 14 Selection process value 1, 2
Function code
From DR
0
-
1
30
2
30
3
30
4
30
5
30
6
30
7
30
8
31
9
30
10
31
Scale parameters and functions
Format
-
FLOAT
FLOAT
FLOAT
FLOAT
FLOAT
FLOAT
FLOAT
LONG
USHORT
UINT
103
Advertisement
Chapters
Table of Contents
