Siemens SIWAREX WP251 Manual page 169

Data and command errors
6056 Memory command
error
7050 Unknown data record
7051 Parameter input not
possible now
7052 Parameter is write
protected and cannot be
changed
7053 Error in calibration
parameter DR 3
7054 Parameter error DR 5
SIWAREX WP251
Manual, 12/2015, A5E37203357A
Error code Additional
string
6056
4500
4501
4502
4511
4532
4550
4551
4552
7050 -
7051
4507
4510
4511
3519
7052
Parameter
ID
7053
Parameter
ID
4510
4520
4521
4524
4525
4526
4610
4611
4613
7054
Parameter
ID
Description
Trace, logging or logbook command was rejected. Additional
information contains details.
, because a fault is present
, because no standstill occurred
, because module is already waiting for standstill
, because write protection active
, because weight is outside the permissible weighing range
, because trace memory full
, because log memory full
, because memory task busy
Requested data record is unknown.
A parameter input is currently not possible. Additional information
contains details.
, because dosing active
, because service mode is not active
, because write protection active
, because password incorrect
A parameter input is currently not possible due to active write
protection. Additional information contains details about the pa-
rameter involved.
Parameter ID of the parameter involved
Additional information indicates an implausible parameter in DR 3
Parameter ID of the affected parameter in DR 3
, because service mode is not active
, because increment between calibration digits is too small
, because order of calibration points is incorrect
, because calibration weight 0
, because falling characteristic curve not allowed by OIML
, because mixed characteristic curve not allowed
, because weighing range max - min error
, because resolution not permitted
, because OIML and 3000d requirements violated
Additional information indicates an implausible parameter in DR 5
Parameter ID of the affected parameter in DR 5
Errors and messages
9.6 Operating errors
169