Error Codes Of Function Block - Siemens SIWAREX WP251 Manual

Communication with SIMATIC S7-1200
11.1 Integration in SIMATIC S7-1200
Parameter (read)
TECHNOLOGICAL_ERR
ORS_1
TECHNOLOGICAL_ERR
ORS_2
DATA_CMD_ERRORS_1
DATA_CMD_ERRORS_2
DATA_CMD_ERROR_AD
D_INFO
Parameter (write)
PRESET_TARE_VALUE
AQ_CONTROL
DQ_CONTROL
TRANSITIONS
SECURE_DISPLAY_CON
TROL
11.1.6

Error codes of function block

Table 11- 2 Statuses/errors when working with the function block
Error bit
bo_ApplIDError
bo_ApplIDDRError
bo_SFBError
bo_RdPerError
bo_LifeBitError
bo_StartUpError
bo_WrongFW
bo_InvalidCMD
bo_DataOperationError
bo_StartUp
192
Meaning
Technology error word 1 according to the "Messages" section
Technology error word 2 according to the "Messages" section
Data/command error word 1 according to the "Messages" section
Data/command error word 2 according to the "Messages" section
Additional information for data/command errors according to the "Messages" section
Meaning
Preset tare value (can be used via command 1016 or with corresponding "Dosing start option"
(DR 25) for taring)
Control value for the analog output (the output must be configured accordingly for this in DR 7)
Control bits for the four digital outputs (the outputs must be configured accordingly for this in
DR 7)
Blocking conditions for weighing steps 0-7. For example, if the "TRANSITION_STEP_2" bit is
set and a weighing is started, WP251 stops the weighing cycle after performing weighing step
1 and sets the "Step blocked (transition)" bit in the AWI Status. The weighing or weighing step
2 is not continued until the "TRANSITION_STEP_2" bit is reset.
Parameter for communication of the calibratable "SecureDisplay" display with the SIWAREX
WP251 module. The "SecureDisplay" communication block is interconnected with this pa-
rameter for scales requiring official calibration.
Error description
Address module does not match the function block
Data record does not match the inserted module
Runtime error during transmission of data record
Reading of I/O data failed
SIWAREX no longer responds
Command was sent although StartUp is still TRUE
Data record version does not match the firmware
An invalid command code was sent
Synchronous data operation error has occurred
Startup synchronization of module running
SIWAREX WP251
Manual, 12/2015, A5E37203357A