Reactivating A Spa - Cisco 7600 series Hardware Installation Manual

Hide thumbs Also See for 7600 series:
Table of Contents

Advertisement

Chapter 5
Installing and Removing a SIP
If you are preparing for an OIR of a SPA, it is not necessary to independently shut down each of the
Note
interfaces prior to deactivation of the SPA. The hw-module subslot shutdown command automatically
stops traffic on the interfaces and deactivates them along with the SPA in preparation for OIR. In similar
fashion, you do not need to independently restart any interfaces on a SPA after OIR of a SPA or SIP.
To deactivate a SPA and all of its interfaces prior to removal of the SPA, use the following command in
global configuration mode:
Command
Router(config)# hw-module subslot
slot/subslot shutdown [powered |
unpowered]
For more information about chassis slot and SIP subslot numbering, refer to the "Identifying Slots and
Subslots for SIPs, SSCs, and SPAs" section in this guide.

Reactivating a SPA

You do not need to reactivate a SPA after an OIR of either the SIP or a SPA if you did not deactivate the
Note
SPA prior to removal. If the router is running, then the SPAs automatically start upon insertion into the
SIP or with insertion of a SIP into the router.
If you deactivate a SPA using the hw-module subslot shutdown global configuration command and
need to reactivate it without performing an OIR, you need to use the no hw-module subslot shutdown
global configuration command to reactivate the SPA and its interfaces.
OL-5052-08
Purpose
Deactivates the SPA in the specified slot and subslot of
the SIP, where:
slot—Specifies the chassis slot number where the
SIP is installed.
subslot—Specifies subslot number on a SIP where
a SPA is installed.
powered—(Optional) Shuts down the SPA and all
of its interfaces, and leaves them in an
administratively down state with power enabled.
This is the default state.
unpowered—(Optional) Shuts down the SPA and
all of its interfaces, and leaves them in an
administratively down state without power.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
Online Insertion and Removal
5-5

Advertisement

Table of Contents
loading

Table of Contents