Configuring The Waveform Display - ZOLL Propaq M Operator's Manual

Chapter 3 Monitoring Overview

Configuring the Waveform Display

You can display up to four waveform traces on the Waveform Display window. The first
waveform trace always uses an ECG lead as its source (such as Leads
default is
to another ECG lead for the first trace. As you insert the remaining three traces, you can specify
that the traces use an ECG lead as the waveform source, or that the trace derive its waveform
from other available monitoring functions (such as
or ).
P3
If configured, the unit can display four ECG traces on startup, when no other monitoring
devices are attached.
The Propaq M unit can also cascade a trace onto the adjoining trace area to double the duration
of the trace display.
On the Waveform Display window, to insert a new trace (
displayed trace, highlight and select the trace label above the trace. In the following example,
the unit is configured to cascade the ECG Lead l trace:
06/06/2012
I, II,
III...
12
CO
2
IBP
Note:
3-6
Pads ). If Pads are not connected, the unit can be configured to automatically default
12:34:56
Source
II 1 cm/mV
I
II
III
aVR
aVL
aVF
V
Insert
Cascade
bpm
HR NIBP
121
80
ºF
T1
79
98.6
The Propaq M unit automatically inserts a new waveform when you turn on a
parameter (CO ) or a new sensor signal is present (SPO
2
automatically removes a waveform when you turn off a parameter or remove a sensor
and the unit displays the resulting equipment alert.
www.zoll.com
, ,
Resp CO2 SpO2
) or cascade (
Insert
Adult
mmHg
CO2
38
(96)
12
BR
2
l , ll , or lll , and so on. The
or IBP channels
P1
) a
Cascade
00:17:43
mmHg SpO2
%
97
, IBP). The Propaq M unit
9650-000820-01 Rev. K
, ,
P2