ZOLL Propaq M Operator's Manual page 77

The unit is configured to display
also display four ECG traces on startup, when no other monitoring devices are attached.
The are two ways to specify which ECG lead is the source of the primary waveform trace. One
way is to press the ECG lead selection quick access key
waveform sources. The available waveform sources are determined by the type of ECG cable
connected to the unit.
The other way to specify the source of the primary waveform trace is to navigate to and select
the source label for the primary ECG waveform (Lead
unit then displays the available ECG waveform sources. The following example illustrates the
waveform source list that the Propaq M unit displays when a 5-lead ECG cable is connected to
it. The list of available ECG waveform sources includes Leads
You can select Lead
displayed ECG lead as the source for the waveform trace.
06/06/2012
I, II,
III...
12
CO
2
IBP
Select a current waveform source, and the unit displays the waveform immediately. If you
select a waveform source that is not currently available, the unit displays the message, LEAD
FAULT.
For more information on how to configure the display of waveforms on the Propaq M unit, see
Chapter 3, Monitoring Overview.
9650-000820-01 Rev. K
Pads
lI (the default), or use the navigation keys to highlight and select another
12:34:56
Source
1 cm/mV
I
I
II
III
aVR
aVL
aVF
V
Insert
Cascade
bpm
HR NIBP
121
80
ºF
T1
79
98.6
Propaq M Operator's Guide
by default for the top trace. If configured, the unit can
I, II, to display the available ECG
III...
in the screen below). The Propaq M
l
Adult
mmHg mmHg SpO2
CO2
38
(96)
BR 12
ECG Monitoring Setup
, , , , , , and
I II III aVR aVL aVF
00:17:43
%
97
.
V
6-7