Disassembly And Reassembly Of The Wheel Guard - Hitachi CM 75EAP Service Manual

17. Disassembly and reassembly of the wheel guard

[Tools required]
• Hex. bar wrench (4 mm)
• Socket wrench (13 mm)
• Flat-blade screwdriver
• Long-nose pliers
(1) Disassembly
• Loosen the two Set Bolts M5 x 16 [71] by using a hex. bar wrench (4 mm), and then remove Handle
(W) [72].
• Remove the two Plates (A) [69] and two Dampers (A) [70] by using a flat-blade screwdriver.
• Loosen the three Lock Nuts [75] and remove the Water Supply Hoses [50] [76].
• Loosen the two Cap Nuts [73] by using a socket wrench (13 mm), and then remove Water Supply
Joint (A) [82] and Water Supply Joint (B) [74].
(2) Reassembly
Reassembly can be conducted by reversing the disassembly procedure. However, special attention
should be given to the following items.
• Insert the Water Supply Hoses [50] [76] until they contact the end faces.
• To secure Water Supply Joint (A) [82] and Water Supply Joint (B) [74], insert the Nozzle Bolt [77] into
the hole of the Wheel Guard [80] by using long-nose pliers and tighten the Cap Nut [73] from the
opposite side.
• Do not mix up the mounting positions of Handle (W) [72], Water Supply Joint (A) [82], Water Supply
Joint (B) [74], and the Stopper Rubber [65].
NOTE: Note that the Models CM 75EAP and CM 75EBP have different Stopper Rubber [65]
mounting positions.
-25-