Disassembly And Reassembly Of The Front Handle - Hitachi CM 75EAP Service Manual

18. Disassembly and reassembly of the front handle

[Tools required]
• Hex. bar wrenches (4 mm and 5 mm)
• Phillips screwdriver
(1) Disassembly
• Loosen the two Tapping Screws D4 x 16 [109] by using a Phillips screwdriver, and remove Grip End
(A) [145] and Grip End (B) [122].
• Loosen the Bolt M6 x 20 [119] by using a hex. bar wrench (5 mm), and remove the Antivibration Spring
[120].
• Loosen the two Bolts M5 [207] by using a hex. bar wrench (4 mm), and remove the Front Adapter
[121], Front Handle [117], Lower Guard [202], Front Foot Holder [204], and Front Foot Plate [206].
• Remove the two Front Foot Rubbers [205] from the Front Foot Holder [204].
• Loosen the four Bolts M5 x 12 [62] by using a hex. bar wrench (4 mm), and remove the Muffler Guard
[203].
(2) Reassembly
Reassembly can be conducted by reversing the disassembly procedure. However, special attention
should be given to the following items.
• Fit the pawls of the Front Foot Holder [204] into the grooves of the two Front Foot Rubbers [205].
• Front handle
[119]
[120]
[121]
[122]
[117]
[58]
[145]
[109]
[205]
[206]
-27-
[202]
[62]
[204]
[207]
[204]
Fit the pawls of the Front Foot Holder [204] into
the grooves of the two Front Foot Rubbers [205].
[205]
[203]