Download Print this page

Advertisement

Cutter
CM 4SB2
HANDLING INSTRUCTIONS
(Diamond wheel is not supplied.)
Read through carefully and understand these instructions before use.

Advertisement

   Summary of Contents for Hitachi CM 4SB2

  • Page 1

    Cutter CM 4SB2 HANDLING INSTRUCTIONS (Diamond wheel is not supplied.) Read through carefully and understand these instructions before use.

  • Page 2

    17mm...

  • Page 8

    17mm...

  • Page 9

    GENERAL SAFETY RULES Lever Base WARNING! Tighten Read all instructions Failure to follow all instructions listed below may Loosen result in electric shock, fire and/or serious injury. Cutting depth adjustment link The term “power tool” in all of the warnings listed be- Bolt (left hand screw) low refers to your mains operated (corded) power tool Washer (A)

  • Page 10

    d) Remove any adjusting key or wrench before turn- SAFETY INSTRUCTIONS FOR CUTTER ing the power tool on. A wrench or a key left attached to a rotating part of Do not use a grinding wheel. the power tool may result in personal injury. Do not use a diamond saw blade not in compliance e) Do not overreach.

  • Page 11

    PRECAUTIONS ON USING CUTTER Proceed with cutting operation when full speed Do NOT use any cutting tool other than a dia- has been reached. mond wheel. Do NOT apply excessive force. Use the diamond wheel specified in this manual. When cutting concrete, tile, or stone, the maxi- Don’t use it for cutting of metallic materials.

  • Page 12

    APPLICATIONS CUTTING PROCEDURES Cutting and scribing of concrete. 1. Set the machine body (base) on the material to be Cutting and scribing various types of stones. cut; use the side on the base to align the diamond Cutting and scribing various types of tiles. wheel with the cutting line.

  • Page 13

    6. Replacing supply cord If the replacement of the supply cord is neces- sary, this has to be done by Hitachi Authorized Service Center in order to avoid a safety hazard. If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord available through the service organization.

  • Page 16

    Hitachi Koki Co., Ltd. Code No. C99148625 G Printed in China...

Comments to this Manuals

Symbols: 0
Latest comments: