Download Print this page

Repair Flow Chart - Hitachi CM 75EAP Service Manual

Engine cutter
Hide thumbs

Advertisement

Pull the starter handle.
Is pulling possible?
No
Yes
Is there compression?
No
Yes
Is there any foreign
matter between the spark
plug electrodes?
Yes
No
Remove the spark plug to
check for sparks.
Are sparks generated?
No
Yes
Return the spark plug
and plug cap to the
original positions, and
then perform proper
startup operation.
Is the tip of the spark plug
wet with fuel?
No
Yes
Is the spark plug wet due
to excessive supply of
fuel?
Yes
No
Repair flowchart
Broken piston ring
Seized piston or cylinder
Seized or broken needle bearing of the crank
shaft
Seized or broken ball bearing of the crank
shaft
Magneto rotor contact with ignition coil
Broken recoil starter
Clogging of dirt in starter pawl
Faulty piston ring
Worn piston ring
Worn piston
Worn or broken oil seal
Worn cylinder
Defective sealing of the packing
Decompression valve trouble
Ignition failure due to contaminant
Stop switch not at startup position
Dirty or faulty spark plug
Improperly connected plug cap
Disconnected or improperly connected high
voltage cord and other wiring
Ground connection of high voltage cord and
other wiring
Disconnected or faulty ignition coil
Improper gap between magneto rotor
circumference and ignition coil
No fuel in fuel tank
Clogged fuel filter
Bent fuel pipe
Cracked fuel pipe
Disconnected fuel pipe
Faulty tank vent hole (tank cap inside plug)
Faulty pump diaphragm of carburetor ass'y
Dirt-clogged carburetor ass'y
Poorly adjusted carburetor ass'y
Pulling the starter handle several times with
the choke button at the "startup" position
-4-
Replace.
Adjust.
Inspect/replace.
Clean.
Clean/replace.
Replace.
Clean (Remove contaminants.)
Set to startup
position.
Clean/inspect.
Inspect/replace.
Inspect.
Replace.
Adjust.
Add properly mixed
fuel (25:1 to 50:1).
Clean/replace.
Adjust.
Replace.
Connect.
Replace.
Clean.
Adjust.
Dry the spark plug.
Remove residual fuel
from cylinder and
crank case.

Advertisement

loading

This manual is also suitable for:

Cm 75ebp