Disassembly And Reassembly Of The Rear Handle - Hitachi CM 75EAP Service Manual

19. Disassembly and reassembly of the rear handle

[Tools required]
• Hex. bar wrench (5 mm)
• Phillips screwdriver
• Jig J-382 (Code No. 6600413) (Inner cap jig ass'y)
• Round bar about 2.5 mm in diameter
• Pliers
(1) Disassembly
• Loosen the seven Tapping Screws D6 [118] by using a hex. bar wrench (5 mm), and remove the Front
Handle [117], Lower Guard [202], and Antivibration Spring [201].
• Loosen the two Tapping Screws D4 x 16 [109] by using a Phillips screwdriver, and remove the Rear
Foot [200].
• Loosen one Tapping Screw D4 x 16 [109] by using a Phillips screwdriver, and remove the Air Vent Cap
[110] and Inner Cap (B) [111].
• Loosen the Tapping Screw D4 x 25 [107] by using a Phillips screwdriver, and remove the Trigger
Lockout [131] and Trigger Lockout Collar [130]. Push the Trigger Lockout [131] towards the Throttle
Lever [134] and pull it out to remove. For details, see the figure on the next page.
NOTE: The Rear Handle Set [114] cannot be disassembled into left and right parts as shown
below even by loosening the three Tapping Screws D4 x 16 [109] that secure the grip
portion, because the fuel tank is welded to the Rear Handle Set [114].
• Rear handle
[107]
[118]
[117]
[110]
[111]
[109]
-28-
[131]
[130]
[109]
[179]
[132]
[133]
[134]
[114]
[202]
[118]
[199]
[198]
[103]
[178]
[200]
[201]
[109]
[118]