Download Print this page

Repair Guide; Precautions In Disassembly And Reassembly - Hitachi CL 10D2 Technical Data And Service Manual

Cordless stud cutter
Hide thumbs

Advertisement

8. REPAIR GUIDE

WARNING: Without fail, remove the storage battery from the main body of the tool before starting repair
or maintenance work. If the battery is left in and the switch is activated inadvertently, the
motor will start rotating unexpectedly, which could cause serious injury.

8-1. Precautions in Disassembly and Reassembly

The [Bold] numbers in the description below correspond to the item numbers in the Parts List and exploded
assembly diagram for the Model CL 10D2.
8-1-1. Preparation to disassembly (Fig. 18)
Before disassembly, set the Pushing Button [3] to the
(A) [42] opens. Then release the trigger switch and remove the storage battery.
Remove the two Special Bolts M5 x 9 [50] from the two Cutter Ass'y M8 [52] with the Hex. Bar Wrench 4 mm [11]
(standard accessory). Insert the storage battery in the main body. Depress the trigger switch keeping the
Pushing Button set to the
release the trigger switch and remove the storage battery.
position
On completion of the above preparation, be sure to
disconnect and remove the battery. Remove the
Bolt W3/8 x 75 [48], loosen the Spring Washer M10
[47], and take off the Stud Guide Ass'y [46]. (Fig. 19)
position until Bracket (A) [42] is positioned to the maximum cutting position. Then
[3]
[42]
(a)
Fig. 18
--- 15 ---
position and depress the trigger switch until Bracket
[37]
[38]
[52]
[50]
(b)
[46]
Maximum
cutting
position
[47] [48]
Fig. 19

Advertisement

loading