Cpu Assembly; Removal - Keysight N8973B Service Manual

Assembly Replacement Procedures

CPU Assembly

CPU Assembly

Removal

The CPU assembly will look like
Figure 15-33 CPU Assembly - Rear Panel View
1. Refer to
2. The CPU assembly can be removed from the chassis by pulling straight out
If the A4BT1 CPU board battery was changed, refer to
"Post-Repair Procedures."
Keysight NFA Series Noise Figure Analyzers Service Guide
Figure 15-34. Remove the six screws (1) attaching the CPU
assembly to the chassis.
the back. Use the two ejectors to pull the CPU assembly out from the
chassis.
Figure 15-33.
for setup instructions.
Chapter 16,
433