Enable Rcc And Lcc On-Demand Scan - Cisco NCS 5500 Series Configuration Manuals

Implementing and Monitoring RIB
DETAILED STEPS
Step 1
router rib
Example:
RP/0/RP0/CPU0:router# route rib
Enters RIB configuration mode.
Step 2
address-family { ipv4 | ipv6 } next-hop dampening disable
Example:
RP/0/RP0/CPU0:router(config-rib)# address family ipv4 next-hop dampening disable
Disables next-hop dampening for IPv4 address families.
Step 3
commit
Output of show route next-hop Command: Example
The following is sample output from the show route resolving-next-hop command:
show route resolving-next-hop 10.0.0.1
Nexthop matches 0.0.0.0/0
/CPU0/0

Enable RCC and LCC On-demand Scan

Perform this task to trigger route consistency checker (RCC) and Label Consistency Checker (LCC) on-demand
scan. The on-demand scan can be run on a particular address family (AFI), sub address family (SAFI), table
and prefix, vrf, or all prefixes in the table.
SUMMARY STEPS
1. Use one of these commands.
2. Use one of these commands.
Known via "static", distance 200, metric 0, candidate default path
Installed Aug 18 00:59:04.448
Directly connected nexthops
172.29.52.1, via MgmtEth0/
Route metric is 0
172.29.52.1, via MgmtEth0/RP1/CPU0/0
Route metric is 0
• show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
• show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
Enable RCC and LCC On-demand Scan
119