Prerequisites For Implementing Rib - Cisco NCS 6000 Series Configuration Manual

Implementing and Monitoring RIB
Routing Information Base (RIB) is a distributed collection of information about routing connectivity among
all nodes of a network. Each router maintains a RIB containing the routing information for that router. RIB
stores the best routes from all routing protocols that are running on the system.
This module describes how to implement and monitor RIB on Cisco IOS XR network.
Note For more information about RIB on the Cisco IOS XR software and complete descriptions of RIB commands
listed in this module, see the Additional References section of this module.
To locate documentation for other commands that might appear during the execution of a configuration task,
search online in the .
Feature History for Implementing and Monitoring RIB
Release
5.0.0
•
•
•
•
•
•
•

Prerequisites for Implementing RIB

• You must be in a user group associated with a task group that includes the proper task IDs. The command
• RIB is distributed with the base Cisco IOS XR software; as such, it does not have any special requirements
This feature was introduced.
Prerequisites for Implementing RIB, on page 353
Information About RIB Configuration, on page 354
How to Deploy and Monitor RIB, on page 357
Configuring RCC and LCC, on page 359
Configuration Examples for RIB Monitoring, on page 360
Where to Go Next, on page 362
Additional References, on page 363
reference guides include the task IDs required for each command. If you suspect user group assignment
is preventing you from using a command, contact your AAA administrator for assistance.
for installation. The following are the requirements for base software installation:
• Router
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
9
C H A P T E R
353