Port Monitor Commands; Port Monitor - Planet WGSD-1022 User Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example shows how all port-channel information is displayed.
Console (config)# show interfaces port-channel
Channel
------------
ch1
ch2
ch3

5.16 Port Monitor Commands

5.16.1 port monitor

The port monitor interface configuration command starts a port monitoring session. To stop a port monitoring session, use the
no form of this command.
Syntax
port monitor src-interface [rx | tx]
no port monitor src-interface
src-interface — Valid Ethernet port or port-channel number.
rx — Monitors received packets only. If no option specified, monitors both rx and tx.
tx — Monitors transmitted packets only. If no option specified, monitors both rx and tx.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration mode
User Guidelines
This command enables traffic on one port to be copied to another port, or between the source port (src-interface) and a
destination port (the port being configured). Only a single target port can be defined per system.
The port being monitored cannot be set faster than the monitoring port.
The following restrictions apply to ports configured to be destination ports:
The port cannot be already configured as a source port.
Ports
-----------------
Active: g2
Active: e3, e7 Inactive: g1
Active: e4, e8
User's Manual of WGSD-1022/WGSD-8000
- 254 –