Show Ports Jumbo-Frame - Planet WGSD-1022 User Manual

OutBcastPkts
FCS Errors
Single Collision
Frames
Late Collisions
Excessive Collisions
Internal MAC Tx Errors
Oversize Packets
Internal MAC Rx Errors
Received Pause
Frames
Transmitted Pause
Frames

5.7.18 show ports jumbo-frame

The show ports jumbo-frame user EXEC command displays the jumbo frames configuration.
Syntax
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Console# show ports jumbo-frame
Jumbo frames are disabled
Counted transmitted broadcast packets.
Counted frames received that are an integral number of octets in length but do
not pass the FCS check.
Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
Counted times that a collision is detected later than one slotTime into the
transmission of a packet.
Counted frames for which transmission fails due to excessive collisions.
Counted frames for which transmission fails due to an internal MAC sublayer
transmit error.
Counted frames received that exceed the maximum permitted frame size.
Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Counted MAC Control frames received with an opcode indicating the PAUSE
operation.
Counted MAC Control frames transmitted on this interface with an opcode
indicating the PAUSE operation.
User's Manual of WGSD-1022/WGSD-8000
- 215 –