Checking The Configuration; Configuring Remote Vlan Mirroring; Establishing The Configuration Task - Huawei V100R006C00 Configuration Manual

Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management

7.5.3 Checking the Configuration

Run the following commands to check the previous configuration.
Action
Check information about the
observing port.
Check information about port
mirroring.
If the following results are obtained, the configuration is successful:
l
l

7.6 Configuring Remote VLAN Mirroring

This section describes how to configure remote VLAN mirroring.

7.6.1 Establishing the Configuration Task

Applicable Environment
When incoming packets passing through any active interfaces of the S5700 in a specified VLAN
or some VLANs need to be monitored, you can configure remote VLAN mirroring if the interface
added to the monitored VLAN is not located on the same S5700 as the observing port.
Pre-configuration Tasks
Before configuring remote VLAN mirroring, complete the following tasks:
l
l
Data Preparation
To configure remote VLAN mirroring, you need the following data.
No.
1
2
3
Issue 01 (2011-07-15)
The type of the observing port is configured properly.
The number of the observing port is configured properly.
NOTE
S5700SI does not support remote VLAN mirroring.
Creating a VLAN as the monitored VLAN
Adding physical interfaces to the monitored VLAN
Data
Type and number of the observing port
ID of the mirrored VLAN
ID of the RSPAN VLAN
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Command
display observe-port
display port-mirroring
7 Mirroring
77