Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
l
l
Data Preparation
To deploy unconfigured switches, you need the following data.
N
o.
1
2
3
4
5
6
1.4.2 Configuring the DHCP Server
Context
The configuration procedure varies according to the device type of the DHCP server. Therefore,
the configuration procedure is not described and only the configuration contents are provided.
Procedure
l
l
----End
Issue 01 (2011-07-15)
Ensuring that there is no *.cfg or *.zip file except the *web.zip and web.zip files in the
flash memory of each switch
Ensuring that the switches are not added to any HGMP cluster and USB upgrade
Data
Interconnection information about the upstream interfaces on each S5700 and the
downstream interfaces on the DHCP relay
Interconnection information about the DHCP relay and DHCP server
MAC address of each unconfigured switch
IP address, mask, address pool, and Option 150 or Option 14x of the DHCP server
IP address, mask, and relay address of the DHCP relay
IP address, default configuration file, and configuration files on the FTP/TFTP server
NOTE
The DHCP server must support either Option 150 or Option 14x.
Enable DHCP server.
Configure an address pool, including the address range, gateway, and Option 150 (or Option
14x).
NOTE
Pay attention to the following points when configuring Option 150 or Option 14x:
l When new switches obtain configuration files through TFTP, the DHCP server must support
Option 150.
l When new switches obtain configuration files through FTP, the DHCP server must support
Option 141, Option 142, and Option 143.
l If both Option 150 and Option 14x are configured on the DHCP server, Option 150 takes
precedence over Option 14x.
l If you use ordinary characters to configure Option 150 or Option 143 on the DHCP server, the
Auto-Config module cannot recognize the IP address.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Auto-Config
10
Advertisement
Table of Contents
