Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
3.
Step 6 Optional: Power on an interface forcibly.
If the PSE cannot identify the PD connected to an interface, you can forcibly power on the
interface. Before powering on the interface, ensure that the system power is sufficient.
1.
2.
3.
----End
8.3.4 Checking the Configuration
Prerequisite
The PoE power supply and PoE board are installed, and the PoE function is configured.
Procedure
Step 1 Run the display poe-power command to view the status of the PoE power supply.
Step 2 Run the display poe device command to view information about the devices that support the
PoE function.
Step 3 Run the display poe information command to view the PoE information.
Step 4 Run the display poe power interface interface-type interface-number command to view the
output power of an interface.
Step 5 Run the display poe power-state interface interface-type interface-number command to view
the status of PoE power supply on an interface.
----End
8.4 Configuration Examples
This section provides an example for configuring PoE on the S5700.
Issue 01 (2011-07-15)
The interface view is displayed.
Run:
poe legacy enable
The interface is enabled to check compatibility of PDs.
By default, an interface does not check compatibility of PDs.
Run:
system-view
The system view is displayed.
Run:
interface interface-type interface-number
The interface view is displayed.
Run:
poe force-power
The interface is forcibly powered on.
By default, an interface cannot provide power for unidentified PDs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 PoE Configuration
117