Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
Context
You can check different items in different phases in the Auto-Config process to confirm that
Auto-Config runs properly.
Procedure
Step 1 Five minutes after unconfigured switches are powered on, check address allocation on the DHCP
server to confirm that the switches are connected to the DHCP server.
Step 2 Five minutes after the switches obtain IP addresses, check the file downloading log on the FTP/
TFTP server or log in to the switches to confirm that correct configuration files have been
downloaded.
Step 3 If the user has specified the activation delay, the configuration file will take effect after the delay.
If the user has not specified the activation delay, the configuration file will take effect
immediately by default. Then run the display current-configuration command to check
whether the configurations take effect.
----End
Issue 01 (2011-07-15)
NOTE
If the switches are connected to the DHCP server, you can log in to the switches through Telnet but do not
configure the switches.
NOTE
Do not save a configuration file to a switch to be configured immediately after the configuration file is
downloaded; otherwise, only a temporary configuration file is saved because the configurations have not
taken effect.
NOTE
If you access the switch when it is busy delivering configurations in the Auto-Config process, the switch
may not respond in real time.
After the configurations take effect, modify the configuration of the downstream interface on the DHCP
relay as required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Auto-Config
12
Advertisement
Table of Contents
