Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
l
7.9 Configuring RSPAN Based on MAC Addresses
This section describes how to configure RSPAN based on MAC addresses.
7.9.1 Establishing the Configuration Task
Applicable Environment
When incoming packets with the specified source or destination MAC address in a VLAN need
to be monitored on the S5700, you can configure RSPAN based on MAC addresses if the
monitoring interface receiving these incoming packets is not located on the same S5700 as the
observing port.
Pre-configuration Tasks
None.
Data Preparation
To configure RSPAN based on MAC addresses, you need the following data.
No.
1
2
3
4
7.9.2 Configuring Remote MAC Address Mirroring
This section describes how to configure remote MAC address mirroring.
Procedure
l
Issue 01 (2011-07-15)
The number of the observing port is configured properly.
Data
Type and number of an observing port
MAC address of the packet to be mirrored
ID of the VLAN that the packet with the MAC address to be mirrored belongs to
ID of an RSPAN VLAN
Configure remote MAC address mirroring on the source switch.
NOTE
The mirrored port cannot be added to the RSPAN VLAN.
The S5700SI series do not support remote MAC address mirroring.
1.
Run:
system-view
The system view is displayed.
2.
Run:
vlan vlan-id
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Mirroring
82