Disabling Nap On The Slave Device; Checking The Configuration - Huawei V100R006C00 Configuration Manual

Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management

2.2.4 Disabling NAP on the Slave Device

If the NAP function is no longer required, you need to disable NAP on the slave interface of the
slave device.
Context
The master device has logged in to the slave device through Telnet. The NAP function is no
longer required, and to ensure security of the network, NAP should be globally disabled on the
slave interface of the slave device.
Do as follows on the switch that is configured as the NAP slave device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
undo nap slave enable
NAP is disabled on the slave device.
----End

2.2.5 Checking the Configuration

After configuring NAP-based remote deployment, you can view the NAP status globally or on
a specified interface.
Prerequisite
NAP-based remote deployment has been completed.
Procedure
Step 1 Using the display nap status command, you can view the current NAP status.
Step 2 Using the display nap interface [ interface-type interface-number ] command, you can view
the NAP status of the specified interface.
----End
Example
Run the display nap status command to view the current NAP status.
<Quidway> display nap status
Slave port status
Nap ip-pool/Mask
Run the display nap interface interface-type interface-number command to view the NAP status
of the specified interface.
<Quidway> display nap interface gigabitethernet0/0/1
Issue 01 (2011-07-15)
: Enable
: 12.12.12.0/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 NAP Configuration
18