Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
Figure 7-7 Networking diagram of local flow mirroring
L2 Switch
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Configuration Procedure
1.
Issue 01 (2011-07-15)
Router
Switch
GE 0/0/1
GE0/0/5
L2 Switch
Configure GigabitEthernet 0/0/24 as an observing port.
Create a traffic classifier and set the traffic classification rule that only the packets with the
802.1p priority as 6 can be matched.
Create a traffic behavior and configure flow mirroring in the traffic behavior.
Create a traffic policy and bind the traffic classifier to the traffic behavior.
Apply the traffic policy to GigabitEthernet 0/0/1 and GigabitEthernet 0/0/5.
Create a VLAN on the Switch. Add GigabitEthernet 0/0/1, GigabitEthernet 0/0/3, and
GigabitEthernet 0/0/5 to the same VLAN in trunk mode.
Name of the traffic classifier: c1
Name of the traffic behavior: b1
Name of the traffic policy: p1
ID of the VLAN created on the Switch: 1
Create a VLAN on the Switch and add interfaces to the VLAN in trunk mode.
# Add GigabitEthernet 0/0/1, GigabitEthernet 0/0/3, and GigabitEthernet 0/0/5 to the same
VLAN in trunk mode. The following takes the configuration of GigabitEthernet 0/0/1 as
an example. The configurations of GigabitEthernet 0/0/3 and GigabitEthernet 0/0/5 are the
same as the configuration of GigabitEthernet 0/0/1 and are not mentioned here.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE0/0/3
GE0/0/24
Mirroring host
7 Mirroring
103
Advertisement
Table of Contents
