Example For Changing An Observing Port - Huawei V100R006C00 Configuration Manual

Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2
#
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan 2
#
interface GigabitEthernet0/0/1
port hybrid untagged vlan 2
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2
#
#
return

7.17.6 Example for Changing an Observing Port

Networking Requirements
As shown in
GigabitEthernet 0/0/24 is connected to host 1; GigabitEthernet 0/0/5 is connected to host 2. To
monitor incoming traffic on GigabitEthernet 0/0/1, port mirroring is configured on the Switch.
Configure GigabitEthernet 0/0/1 as a mirrored port, and GigabitEthernet 0/0/24 connected to
host 1 as an observing port. Enable host 1 to receive incoming traffic from GigabitEthernet 0/0/1.
At present, host 2 needs to receive incoming traffic from GigabitEthernet 0/0/1. Therefore, the
observing port needs to switch from GigabitEthernet 0/0/24 to GigabitEthernet 0/0/5.
Issue 01 (2011-07-15)
Figure 7-9,GigabitEthernet 0/0/1 on the Switch is connected to an L2 switch;
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Mirroring
108