Deploying Unconfigured Switches (Different Network Segments); Establishing The Configuration Task - Huawei V100R006C00 Configuration Manual

Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
immediately by default. Then run the display current-configuration command to check
whether the configurations take effect.
----End
1.4 Deploying Unconfigured Switches (Different Network
Segments)
This section describes how to deploy unconfigured S5700s.

1.4.1 Establishing the Configuration Task

Applicable Environment
As shown in
server. A PC is connected to the DHCP server and functions as an FTP or a TFTP server to store
configuration files. After the DHCP server and FTP/TFTP server are configured, every switch
obtains a configuration file through Auto-Config.
The DHCP server, FTP/TFTP server, and switches are deployed on different network segments.
Figure 1-3 Auto-Config networking where the DHCP server, FTP/TFTP server, and
unconfigured switches are on different network segments
SwitchA
SwitchB
SwitchC
Pre-configuration Tasks
Before deploying unconfigured switches, complete the following tasks:
l
Issue 01 (2011-07-15)
NOTE
If you access the switch when it is busy delivering configurations in the Auto-Config process, the switch
may not respond in real time.
After the configurations take effect, modify the configuration of the downstream interface on the DHCP
server as required.
Figure 1-3, unconfigured switches are reachable from a DHCP relay and a DHCP
DHCP Relay
Ensuring that there are routes from the DHCP server, DHCP relay, and FTP/TFTP server
to the switches
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Network
DHCP Server
1 Auto-Config
Operator
FTP/TFTP Server
9