Table of Contents
Advertisement
Settings and Measurement
Network Time Settings
The GL900 has a feature of synchronizing the time of the built-in clock with that of a time server via
an Ethernet.
This menu is used to make settings required to use this feature.
Network Time
Time Server
Time Zone
Synchronized Time
Synchronization Mode
Connection Test
CAUTION
The synchronization is not performed if the error with the time server is 500 ms or more.
(6) FILE Menu
This menu is used to perform file-related operations.
3-36
Setting
Enables or disables this feature.
Off : Disables this feature. The time adjustment is not performed.
On : Enables this feature. The time adjustment is performed.
Specifies the domain name of the time server to be used.
Sets the time zone of the area in which the GL900 is to be used (Japan: +09:00).
Sets the time at which the GL900 clock is to be synchronized with the time server.
When the setting time comes, the synchronization operation in the local country is
performed with a method specified in Synchronization Mode.
Immediately, Gradually
Sets a method in which the clock is to be synchronized with the time server.
Immediately : Immediately synchronizes the clock with the time server when the time for
Gradually
Performs a connection test by connecting to the time server.
After the connection test is performed, a message is displayed.
If connection fails, check the settings and conduct the connection test again.
If the connection test is a success, the following message is displayed.
Selections available
synchronization comes.
: Does not immediately synchronize the clock when the time for
synchronization comes.
Gradually synchronizes the clock with the time server.
The adjusted length of time is about 43 seconds per day (approximately
equal to 10 ms per 20 seconds).
Advertisement
Table of Contents
