General Procedure - Omron DST1-ID12SL-1 Operation Manual

General Procedure

2-1 General Procedure
46
The general procedure for using the DST1-series Safety I/O Terminals is
given below.
Refer to the DeviceNet Operation Manual (Cat. No. W267) for the network
structure and the topology.
Install the DST1-series Safety I/O
Terminals in the control panel.
↓
Wire I/O power and cables.
↓
Connect communications connectors.
↓
Set the node address.
↓
Configure the system.
The baud rate of the entire system is determined by the baud rate of the Mas-
ter Unit. The baud rate does not need to be set for each DST1-series Safety
I/O Terminals.
Node address switches
Refer to Section 2-5.
Communications
Connector
Refer to Section 2-4.
Section 2-1
Make settings for the DST1-
series Safety I/O Terminals.
Refer to Section 3.
Indicators
Refer to Section 4-2.
Terminal blocks
Refer to Section 2-3.