Omron DST1-ID12SL-1 Operation Manual page 44

Logic Functions
Data That Can Be Set for Additional Outputs
S Same value as safety output
terminal
S Inverse value of safety output
terminal
Reset required indication
RUN Status Flag
Normal Status Flag
Note
IMPORTANT When additional output data is set, safety output terminals will reflect the out-
Note
20
Additional output data
Turns OFF (0) when one of the errors shown in 7-3 Error History occurs.
put status even in Idle Mode.
(1) An additional output can be used only when the output terminals are set
as a single channel.
(2) An ON delay or OFF delay can be set for safety output terminals even
when an additional output is set.
Description
Outputs the same value as any safety output terminal.
Outputs the inverse value of any safety output terminal.
Outputs a 1-Hz pulsing signal to trigger a reset input. The sig-
nal is output when resetting is enabled for one or more termi-
nals from among all the safety input terminals.
Outputs the operating mode.
0: Not RUN mode
1: RUN mode
Outputs the status.
0: Error (See note.)
1: Normal
Section 1-5