Event Action Examples - YOKOGAWA SMARTDAC+ GX10 User Manual

1.15.2 Event Action Examples
IM 04L51B01-01EN
Example 1: Starting/Stopping Recording through Remote Control
Starts or stops recording when a remote control signal is applied to DI channel 0101. This
example assumes that a DI module is installed in slot 1 of the GX/GP.
Use event action number 1.
Setting the Mode of the DI Module
• Setup Screen
MENU key > Browse tab > Setting > Setting menu Measurement settings > Module
settings Select module > Module 1 GX90XD-16-11N
• Setup Items
Setup Item
Operation mode Operation mode
Configuring the Event Action
• Setup Screen
MENU key > Browse tab > Setting > Setting menu Display settings > Event action
• Setup Items
Setup Item
Event action number
Event action On/Off
Event Type
Number
Operation mode
Action Type
Operation
If the DI channel 0101 input is turned on when recording is stopped, recording starts. If the
DI channel 0101 input is turned off when recording is in progress, recording stops.
Example 2: Writing a Message When an Alarm Occurs
Write the message "Channel 1 Alarm" to group 1 when an alarm occurs on channel 0001.
This example assumes that an AI module is installed in slot 0 of the GX/GP. Use event
action number 2.
Configuring the Event Action
• Setup Screen
MENU key > Browse tab > Setting > Setting menu Display settings > Event action
• Setup Items
Setup Item
Event action number
Event action On/Off
Event Type
Number
Alarm level
Operation mode
Action Type
Number
Other Settings
• Set AI channel 0001 to alarm level 1.
Setup: See page 1-19 in section 1.2.2, "Setting Alarms".
• Register "Channel 1 Alarm" in message number 1.
Setup: See page 1-84 in section 1.7.3, "Setting Messages".
1.15 Configuring the Event Action Function
Value
Remote
Value
1
On
Remote
0101
Rising / Falling edge
Recording start/stop
Value
2
On
Alarm - IO channel
0001
1
Rising edge
Message
1
1
2
3
4
5
App
Index
1-133