Advanced Features Menu - Thermal Dynamics CUTMASTER 60i Service Manual

CUTMASTER 60i
5.10

Advanced Features Menu

Advanced Features Menu
Entering the advanced features menu allows monitoring the following:
• Pressure (in PSI)
• Number of Pilot Starts
• Volts electrode to work
• Current, both pilot and transferred.
• Arc hours displayed in tenths of hours.
You enter the advanced menu by pressing both upper and lower knobs simultaneously for 3-5 seconds. Once
in the advanced menu you cycle through the parameters being measured by repeatedly pressing the bottom
button. Pressing the top button repeatedly cycles between the parameter name and the number.
In the advanced menu you will remain in whatever mode you were in before (RUN, LATCH, RAPID AUTO
RESTART (RAR), GOUGE or SET/PURGE). In order to see the pressure for SET/PURGE, you must be in SET/
PURGE before entering the advanced menu. In the SET/PURGE mode you will not see current or arc voltage.
In cutting modes you will not see pressure until you trigger the torch.
Upon entering the advanced menu the display shows
Pressing the top knob changes the display to the number in PSI.
Pressing the bottom knob switches to
cumulative number of starts.
Pressing the bottom knob again switches to
the display to the actual volts. At idle, the volts display shows 10 to 15 which is the voltage described under the
E005 fault code description which is applied to the tip for testing if the tip and electrode are in contact. During
pilot or transfer it is the actual electrode to tip (pilot) or to work (transferred) voltage.
Pressing the bottom knob again switches to
the display to the actual current. During pilot it shows pilot current, usually 24-26A. Once the arc is transferred
it is the actual current +/- one amp.
Pressing the bottom knob again switches to
the display to show tenths of arc hours.
You exit the advanced menu returning to pervious operating mode by momentarily pressing both knobs again.
5-34
meaning Starts. Pressing the top knob shows the
meaning volts. Pressing the top knob changes
meaning current. Pressing the top knob changes
meaning hours. Pressing the top knob changes
SERVICE
indicating pressure.
Manual 0-5475