CUTMASTER 60i
Fan Replacement
After cover removal you can access fan on the top of the power supply. To remove the fan do the following:
1. Locate the fan wiring harness and unplug from the PCB.
2. Spread the two retaining clips apart only enough to remove the fan
Proedure is now complete.
5-40
NOTE!
Note the orientation of the fan and where the wires are routed from the
fan so you are able to install the new fan exactly the same way.
Fan Harness
Plug
Retaining Clips
SERVICE
Art # A-13310
Art A-13311
Manual 0-5475