Primary Input Power Connections, Three Phase - Thermal Dynamics CUTMASTER 60i Service Manual

3.05

Primary Input Power Connections, THREE Phase

!
Manual 0-5475
WARNING
Each CutMaster 60i system is a dedicated 1 Phase OR 3 Phase
system and cannot be reconfigured to the other. Personal injury
could occur if changing the phase is attempted..
CAUTION
The primary power source, fuse, and any extension cords used must
conform to local electrical code and the recommended circuit protec-
tion and wiring requirements as specified in Section 2.
Three-Phase (3ø)
Power Switch
Three Phase Input Power Wiring
NOTE!
As long as the power supply is connected to
input power ranging from 208 VAC to 480
VAC, the system will automatically detect
this and run accordingly.
INSTALLATION
Power
Cord
GND
CUTMASTER 60i
3-3