Thermal Dynamics CUTMASTER 60i Service Manual page 32

CUTMASTER 60i
Select Cutting Mode
1. Press and release the upper knob without turning to enter the mode selection menu. Place the system in
one of the four cutting modes available by pressing and releasing the knob until you reach the desired
mode.:
RUN
LATCH .
RAPID AUTO RESTART
GOUGE
SET/PURGE (gas flow only)
2. After selecting the cutting mode, set the output current by turning the knob.
Set Torch Parameters
1. Press and release the bottom knob without rotating to enter the torch type and leads length selections.
4-6
Art # A-13251
OPERATION
1
2
Manual 0-5475